Making water safe to drink
In 30 seconds
When in doubt, drink bottled water. If you have none, boil the water for at least 1 minute or disinfect it with bleach without perfume or detergent, at the dose for the strength on the label, and wait 30 minutes. None of these methods removes chemicals or fuel.
On this page
Public network water is monitored and is normally safe. After floods, storms or supply failures it may stop being safe, and water from wells, springs and other private sources is more exposed. Always follow your water operator’s notices first: a notice to boil water and a notice not to use it are different things.
Safety
Boiling or disinfecting with bleach kills germs, but does not remove chemicals or fuel. If the water may have been contaminated by them (in a flood, for example), do not drink it, even after treating it. Use bottled water and follow the authorities’ instructions.When it may not be safe
- Your tap water has changed colour, smell or taste, or your water operator has issued a notice.
- There have been floods or storms in your area, especially if you use water from a well or spring.
- In those cases, drink bottled water. Also use it to prepare food and babies’ meals, wash fruit and vegetables, brush your teeth and make ice, until an official body confirms the water is safe.
If the water is cloudy
- Let the dirt settle and pour off the clearer water. Pass it through a clean cloth or coffee filter before boiling or disinfecting it.
- This is not enough to make it safe to drink. Particles can make disinfection harder. If chemicals are suspected, use another source, even if the water becomes clear.
If you have no bottled water: boil it
- Boil the water for at least 1 minute at a rolling boil (the water moves and makes large bubbles).
- Let it cool and keep it in a clean, covered container, somewhere cool.
Or disinfect it with bleach
- Only use plain bleach: sodium hypochlorite, with no perfume, no detergent and not thickened. Never use other cleaning products.
- If the label has instructions for disinfecting drinking water, follow them.
- If it does not, check the strength on the label and add, with a dropper, for each litre of water:
- 1% hypochlorite: 4 drops;
- 2%: 2 drops;
- 4%: 1 drop;
- 8% or 10%: 1 drop per 2 litres.
- If the water is cloudy, coloured or very cold, use double.
- If you do not know the strength, do not use the bleach: boil the water.
- Mix well and wait 30 minutes before drinking.
- Bleach works less well than boiling against some parasites, such as Giardia and Cryptosporidium. For water from streams, rivers, wells or springs, boiling is better.
Options when there is no bottled water
- If the water is cloudy, let the dirt settle and pour the clearer part through a clean cloth or coffee filter. If you suspect chemicals or fuel, use another source. Prefer bottled water.
- If you have no bottled water, bring it to a rolling boil for at least 1 minute. Let it cool and store it in a clean, covered container.
- Alternatively, use plain sodium hypochlorite bleach, with no perfume, no detergent and not thickened. Follow the label if it says how to disinfect drinking water. Otherwise, per litre use 4 drops at 1%, 2 at 2%, 1 at 4%, or 1 drop per 2 litres at 8% or 10%. If the water is cloudy, coloured or very cold, use double. If the concentration is unknown, boil instead. Mix and wait 30 minutes before drinking.
Filters: check what they remove
- Tell a microfilter from a purifier. A microfilter with an absolute pore size of 0.2 micrometres (µm) can remove bacteria and protozoa, if it is undamaged and used as directed. Do not rely on it to remove viruses.
- Check the claim on the label. Look for tests or certification for the germs you need to remove. A general mention of NSF is not enough: NSF/ANSI 42 mainly covers things like taste; 53 or 58, when they state cyst reduction, do not guarantee virus removal. P231 is a protocol for microbiological purifiers.
- Combine methods when needed. For water that may carry viruses, use a system proven against viruses, or filter and then disinfect with a suitable product, following the pack. Boiling is another option.
- Have a backup. A filter can clog or get damaged. Follow the maintenance instructions and avoid contaminating the clean-water outlet.
Tablets made for drinking water
- Read the active substance and what it is for. Only use products meant for treating drinking water. Do not use swimming-pool tablets or mix products.
- Chlorine, including NaDCC: follow the water volume and contact time on the pack. Cold water may need longer. Chlorine does not reliably kill the parasite Cryptosporidium; where that risk exists, boil the water or also use a filter proven against that parasite.
- Chlorine dioxide: some products work against Cryptosporidium, but they may need several hours. Wait the full time stated and protect the water from light as the instructions say. Do not apply the time for a chlorine tablet to another product.
- Silver on its own: it is for keeping water that is already safe. Do not use it as the only treatment for water from rivers, wells or untested springs.
- Keep the tablets in their original packaging. Protect them from heat and damp, follow the maker’s storage conditions and check the expiry date. Do not mix loose tablets from different products.
Ultraviolet light devices
- Only use them in clear water. Dirt can shield germs from the light. Clear the water first and follow the device’s manual.
- Check the power and the full cycle. The device needs the batteries or charge it was designed for. If it shows a fault or does not finish the treatment, do not count that water as disinfected.
Solar disinfection: important limits
Solar disinfection, known as SODIS, depends on the light received, how clear the water is, the container and the exposure time. It is not just leaving a bottle in the sun.
- Do not apply a universal time to Portugal. Exposure conditions and results vary. This guide does not give a single solar disinfection time for any place or season.
- Choose a method whose conditions you can meet. Use bottled water, boiling or a suitable treatment system, rather than assuming a few hours in the sun are enough.
Why iodine is not included
Iodine has important limits, including for people who are pregnant or have thyroid problems, and it is not suitable for long-term use. This guide does not give an iodine method. Do not improvise with iodine tincture or antiseptics from the first-aid kit. Use the methods above instead.
After a flood
- Wells and springs reached by floodwater: treat the water as unfit to drink until the authorities say otherwise. Use another safe source.
- See also Floods.
Questions about your health? Call SNS 24 (808 24 24 24). In the Azores and Madeira, use the regional health line, listed in your local contacts.
Sources
- DGS (Directorate-General of Health) — Food safety and general care after power cuts
- DGS (Directorate-General of Health) — Storms: essential care and safe behaviour
- ASAE (Portuguese food and economic safety authority) — Risk communication: extreme weather events
- DGS (Directorate-General of Health) — Wildfires: risks (disinfecting water with bleach)
- Backer, Derlet and Hill / WMS — Water Treatment… 2024 Update
- NSF — NSF Standards for Water Treatment Systems
- Luzi et al. / Eawag-Sandec — SODIS manual
- WHO — Household Water Treatment and Safe Storage Following Emergencies and Disasters: South Asia Earthquake and Tsunami
- WHO — Boil water: technical brief
- CDC (USA) — How to Make Water Safe in an Emergency
- CDC (USA) — About Water Treatment Options When Hiking, Camping, or Traveling
- Katadyn — Micropur Forte MT1 NaDCC: technical sheet (in French)
- Katadyn — Micropur Classic powder: fact sheet
- Katadyn — Steripen Adventurer Opti: Quick Start Guide / Directions for Use
- UKHSA (UK Health Security Agency) — How to recover from flooding
- Katadyn / Washington State University PICOL archive — Micropur MP1: label and directions
- Kersia / Aquatabs — Frequently Asked Questions
Related
Storing water at home
Store 3 litres of water per person per day, for at least 3 days. Choose bottled water, kept somewhere cool and dark, away from chemicals, because heat, light and vapours spoil water through the plastic. Never use containers that have held chemicals, even if well washed.
Dehydration, salt and electrolytes
Water and salt go together: sodium helps the body keep water in the right places. Water needs vary with heat, effort, age and illness. Save sweat and do not put off drinking to make your supply last longer. Confusion, loss of consciousness or difficulty breathing need a call to 112.
Finding and collecting water away from home
Choose bottled water or a tested supply. A fountain, stream or rainwater can contain germs and chemicals, even when the water is clear. Check local notices and treat water from untested sources; if you suspect chemicals, choose another source.